You are currently viewing Why Does My Oil Boiler Keep Locking Out?

Why Does My Oil Boiler Keep Locking Out?

  • Post author:
  • Post published:
  • Post category:Boilers

An oil boiler locks out when it tries to light and can’t detect a flame, so it shuts down for safety. The usual causes are a low oil level, a blocked filter, water or sludge in the oil, a worn nozzle, a dirty photocell or a failing pump or ignition part. Reset it once. If it locks out again, stop pressing the button and call an OFTEC registered technician. If your boiler is old and keeps failing, our oil boiler installation team can talk you through replacement. We cover Thame and the villages around it.

What a lockout actually is

Each time the boiler starts, the burner sprays a fine mist of oil, an ignition spark lights it, and a sensor called a photocell checks there’s a flame. If no flame is seen within a few seconds, the control box shuts everything down and the lockout light comes on. It’s a safety feature that stops unburnt oil building up in the combustion chamber.

Checks you can safely do first

  • Check the oil level. Look at the tank gauge or dip it if that’s how yours works. An empty or very low tank is the simplest cause.
  • Make sure the fire valve and any isolating valve are open. These are on the oil supply line between the tank and boiler.
  • Check the power. Make sure the boiler has power and the timer and thermostat are calling for heat.
  • Reset once. Press the lockout reset button once and wait. If it fires and runs normally, keep an eye on it.

Don’t keep pressing reset. Repeated resets can flood the combustion chamber with oil, which makes the problem worse and can be dangerous when it does light.

Common causes of repeated lockouts

Blocked oil filter

The filter between the tank and burner catches debris and sludge. When it clogs, not enough oil reaches the burner.

Water or sludge in the tank

Condensation can build up in oil tanks, and sludge settles at the bottom over the years. If it gets drawn into the supply line, the burner can’t fire properly. Low tank levels make this more likely, which is why it’s best not to run a tank right down.

Worn or blocked nozzle

The nozzle sprays oil in a fine mist. If it’s worn or partly blocked, the spray pattern is wrong and the flame won’t light or hold. It’s normally replaced at each service.

Dirty or faulty photocell

If the photocell is covered in soot or failing, it can’t see the flame and shuts the boiler down even though it lit.

Pump, ignition or control box faults

The fuel pump, ignition electrodes and control box all wear over time. These are diagnosed and replaced by an engineer.

Air in the oil line

After running out of oil or a filter change, air can get into the line. The pump needs bleeding before the boiler will run reliably.

Why lockouts are more common in winter

The boiler is running for longer every day, so a filter or nozzle on its way out fails sooner. Cold snaps can thicken oil slightly in exposed supply lines, and condensation inside the tank increases. A boiler that hasn’t been serviced for a while is often the one that starts locking out in November.

All work on the burner, pump and oil supply should be done by an OFTEC registered technician.

Oil-fired homes around Thame, Bicester and Witney

Many villages across rural Oxfordshire and the Buckinghamshire border are off the gas grid, and oil heats plenty of farmhouses, cottages and older stone homes. Tanks are often at the far end of a garden or yard, so supply lines can be long and exposed. Around Bicester, Witney and the Thame villages, keeping the tank topped up and the boiler serviced each autumn is the best way to avoid a mid-winter lockout. If you’re weighing up your fuel options, our post on LPG vs oil heating compares the two.

Frequently asked questions

How many times can I reset my oil boiler?

Once, maybe twice if you’ve just had the tank filled. If it locks out again, stop and call an engineer. Repeated resets can push extra oil into the combustion chamber, which can cause a dangerous flare-up when it finally lights. A lockout that keeps happening is a sign something needs fixing.

Can a blocked oil filter cause a lockout?

Yes, it’s one of the most common causes. A blocked filter starves the burner of oil, so it either fails to light or the flame goes out. Filters are normally replaced during an annual service, which is another reason not to skip it. An OFTEC technician can change the filter and bleed the line.

Why does my oil boiler lock out after the tank is filled?

A fresh delivery can stir up sludge and water from the bottom of the tank, which then gets drawn into the filter and supply line. It’s worth waiting a little while after a delivery before running the boiler if possible. If lockouts keep happening, the filter and tank may need attention.

Oil boiler keeps stopping?

Give us a call on 01865 602 994 or drop us a message and we’ll find out why your boiler keeps locking out and get it running reliably again.